All Electronic Components

6TL Engineering

VPC - Mass Interconnect Solutions

DC-DC Converters

Rugged Computers and Military LCD

Connectors Accessories

Beltronic - rugged PC display solutions

Verivolt - sensing platform

Show All

isolate & Protect Signals
Connectivity boards
Measure Current
Measure Voltage Sensors
Display Solutions
Rugged Tablet PCs
Rugged Notebooks
Industrial Tower PC
Rugged 19" Industrial PC
Customized GETAC rugged Notebook
Portable PXI
Transportable rugged Embedded PC
Bison"- Embedded PC
YAV90CLR - cost effective and accurate automatic LED test device, with National Instruments LabView drivers
YAV91500 2,5 GHz 15 relays switching-multiplexer board 50ohm
YAV91501- YAV91501 2,5GHz 50Ohm SMB Multiplexer
YAV90ISP - designed to simplify and standardize the wiring in testing platforms that use fast ISP and/or I2C / SPI data communications.
YAV9JTAG - Fully open general application JTAG I/O Interface
YAV9JTAG - Fully open general application JTAG I/O Interface
YAV90058 - Data Communications MUX
YAV90TC1 - VPC90 RCV to terminals interface board. Cost effective wire harness tester for wire ends of plug-in terminals or free with or without terminals.
YAV90TC2 - VPC 96 RCV to connectors interface. Wire harness tester for wire ends of standard connectors, male or female.
YAVTB000 - adding test points for manual test probes and a 4 position DIP switch.
YAV90Q04 - connect two YAV90096 boards to one 192-Signal contacts Quadrapaddle module.
YAV9COM6 - Communications interface board
J90USBI - USB connection for ITA
J90USBR - USB connection for RCV
Power Switches - YAV91X12, YAV90PIN, YAV90CIN
YAV90G10C - the most ad-ventageus way to handle frequencies up to 6 GHz inside automatic testing platforms
Switches - YAV90132, relays YAV90164, YAV90061, YAV90064
YAV90128 - all combinations of signal computation at low frequency between the device under test and the various measuring instrumentation inside a test system
Matrixes - YAV90060 Matrix, Crosspoint Matrix, audio/video multiplexer
YAV90MMU - Multiplexed Measurement Unit (MMU) contents 16 isolated, 500V data acquisition channels with CAN bus port.
YAV90832 - Multifunction board with 80 in/out
YAV90096 - 96 Channel AI, Sink/Source DIO board. National Instruments LabView drivers
YAV90096I - 96 Sink/Source Inputs/Outputs with National Instruments LabView drivers
YAV90321 - 48 Optocoupled digital inputs
YAV90048 - 48 Optocoupled open Drain 42V-6A DOs
H73000700 - Power Management & MMI module, providing also safety controls, data bus interfaces, temperature control and timers.
H730008xS - Intelligent Power Distribution Unit (PDU) & Switching on the devices sequentially
H78001000 - Indicator of machine Status - CAN bus
H74050100 - Harmonic Analyzer Real Sound
H730035xx - Matrix switching high voltage CAN bus in 19 inch rack
H73003000 - 19 Chassis for special applications
H73000301 - Power management & MMI module Lite version, the interface between an operator and a SYSTEM as well as being a PDU for it.
OFF-LINE Testing platforms - 6TL-19 Testing platform (no mass-interconnect)
iCon’s rugged engagement mechanism is designed for 10,000 cycles with a wide variety of I/O options. PCB mountable for even more connection capabilities
i1 features various I/O solutions in one iCon module system. Simplistic half-turn engagement as well as easily removed backshell support easy connections.
i2 Micro iCon is a very high density signal connector—up to 168 signal pins in 0 .8" footprint. i2 Hybrid delivers about 120 signal as well as twelve micro coaxial or micro power position at the same footprint.
G6 offers a range of I/O options in a small footprint. Engage up to 1,440 signal contacts.
G2’s portable size and also versatile modular I/O solutions deliver a comfortable option to limited I/O connectors.
The G10 solution, engage up to 2,400 signal contacts using QuadraPaddle technology.
The S6’s low profile allows 1,440 points using QuadraPaddle while only taking up 1U of rack space.
G12’s simple and easy dock gliding offers an option of leading a fixture into place previous to engagement. Best feature when making use of large scale fixtures.
The G12x has Just about all the advantages of the G12, with six added modules for better I/O needs. Accepts either G12 as well as G12x ITAs.
The Gemini G18, discrete wiring, with vertical Hinged Mounting Frame that bolts directly onto any common 19” rack and then allows the G18 to hinge down for easy access wiring.
Gemini G18 module - engaging mechanism by means of a pair of accuracy machined slides found in the receiver. Accurate signal integrity between the Receiver and ITA is managed by QuadraTrack™ engagement system.
G20 features immediate connection to instrument modules, providing pull through removal of connector modules as well as instrumentation from the chassis backplane.
G20x delivers the attributes of the G20 system, and in addition provides a further eight modules in an extended section for increased I/O requirements.
G40x is a 2 section, 48 module system, that allows pull-thru removing of 40 VPC modules, pull-thru adapters together with test instrumentation in a single unit. It provides 8 standard/90 Series discrete-wire slots, and a place for two iCon device
G14x delivers all of the options that come with the G20 sys, yet in a small frame. It offers 14 vertical modules with the option to extend as much as 6 extra modules in a horizontal layout.
The Pull-Thru Adapters suit the PXI connection requires. They operate in Pull-Thru options and are suitable for PXI 20 slot chassis. The Parts are suitable for National Instruments’ cards using discrete wire from the board to the VPC module.
The 9025 is best for rack mounting application, saving up time with rapid changeover. It may be directly mounted to the rack or even used in a slide mount setting to access wiring and also instrumentation
The updated Receiver of the 9025TR with enhanced mechanical advantage indicates VPC’s continuous improvement. The platform provides a smooth-sliding action with the captive mounting hardware included.
The 9025VXI Solution is a high I/O system ideal for rack mounting applications. It can be used on a Vertical Hinged Mounting Frame to access wiring and instrumentation and saves time with rapid changeover.
9050 Receiver is made to work with both 9025 & 9050 ITA’s for greatest variety .
9050 TR Module solution with platform ITA support. Platform supports up to 180 lbs alone, and up to 350 lbs with optional leg kit.
9050 VXI uses VXI system adapters to VXI instrumentation over the top level, with 90 Series modules on the bottom section for discrete wiring as well as PCB adapters.
9075 delivers an array of I/O options among them signal, coaxial/RF, power, pneumatic, vacuum, thermocouple, and PCB solutions. It is modular in addition to reconfigurable for developing test requirements.
3SE Series
MVS Series
LE9k Series
JHE Series
EHS Series
YS16e Series
AS Series
Israel Made Rugged Computer
Israel Made LCD
Israel Made Monitor
Rugged Display 55" SKSD5500WUP
Multi Screen
Rugged Display 3.4" SKSAQ240M
Rugged Display 4.2" SKSAQ420M
Rugged Display 6.4" SKSD0640VGE
Rugged Display 6.4" SKSA0504VGE
Rugged Display 8.4" SKSA0507SV
Rugged Display 8.4" SKSA0705SV
Rugged Display 10.4" SKFD0806XGR
Rugged Display 10.4" SKSD1040XGP
Rugged Display 10.4" SKSA0608XG
Rugged Display 12.1" SKSA1007XG
Rugged Display 15" SKSD1500XGP
Rugged Display 15" SKSD1500XGR
Rugged Display 19" SKSD1900SXR
Rugged Display 20.1" SKSD2010UXR
Rugged Display 20.1" SKSD2010UXC
Rugged Display 20.1" SKSD2010UXP
Rugged Display 21.3" SKSD2130UXR
Rugged Dispay 23.1" SKSD2310UXS
Rugged Dispaly 24" SKSD2400WUR
Rugged Display 26" SKSD2600WUR
Rugged Display 46" SKSD4600WUP
10" Rugged Computer SKSC1040P-ME
MS connectors 3102E / MS 3102R
MS connector 3100E / MS 3100F
MS connector 3101E / MS 3101F
MS connector 3106F / MS 3106E
MS connector 3108F
MG 00F
MG 06F
MG 01F
MG02R
MG08F
MG00T
Coaxial Cable Connectors
Standard Receptacles
PC Board Receptacles
Field Replaceable Receptacles
Cable Terminations
Thermometer - High Performance Series
Thermometer - Compact Series
Handheld Sensor
Custom Cable Harness Assembly
MIL-C-915 Shipboard Cable
Round and Flat Braided Tinned Copper Wire
MIL-DTL-3432 CO Cables
Copper Buss Bar
Coaxial Cable
MIL-C-85485 | SAE AS85485
MIL-W-76
MIL-W-5086 Aircraft Cable
MIL-W-8777
Mil-DTL-M16878 Hook Up Wire (M16878)
M16878 Type E Shielded Cables
MIL-W-22759 (M22759) | SAE AS22759
MIL-C-24640 Shipboard Cable
Low Smoke Shipboard Cable
MIL-W-25038
MIL-DTL-27072 (M27072)
MIL-C-27500 Cables | NEMA WC 27500 Cables
MIL-DTL-49055 Ribbon Cable
MIL-W-81044 | SAE AS81044
MIL-W-81381 | MIL-DTL-81381
MIL-W-81822 Wire Wrap
Boeing Specs (BMS 13)
MIL-C-13486 and MIL-C-13777
MIL-C-55021 | NEMA WC 55021
10603 Hook Up Wire (HTXE) Army Drawing 12293251
Cable Clamp MS 3057 A
Telescopic Bushing MS 3420
Protective Metal Caps MS 25042
Protective Metal Caps MS 25043
Protective Plastic Caps
Square Gaskets